Xerox 6250N Service Manual - Page 50
Transfer Roller Assembly Control, Detecting the Installation of the Transfer Roller Assembly
![]() |
UPC - 095205770407
View all Xerox 6250N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Transfer Roller Assembly Control Detecting the Installation of the Transfer Roller Assembly Although there is no seperate sensor for this, the output of the CTD Sensor is used to detect installation or absence of the Transfer Roller when power to the printer is turned on, or the front cover is opened and closed. Light emits from the LED of the CTD sensor with the specified intensity and if the output of the CTD Sensor is greater than the specified value the controller signals that the Transfer Roller is present (installed). If printing is stopped by a jam, the toner image will be placed on the Transfer Roller. In this case the sensor output result is low, causing the controller to report the Transfer Roller as missing. To prevent this, the Transfer Roller is rotated a half turn if output is lower than the specified value. If the output of the CTD sensor is than greater than the specified value, the controller reports installation of the Transfer Roller. If the output remains less than the specified value, the controller reports that the Transfer Roller is not installed. Detecting the Life of the Transfer Roller Assembly The Transfer Roller Assembly consists of a bias transfer roller and a waste toner recovery space. End of life of the Transfer Roller is detected when the waste toner recovery space becomes full. The full waste toner recovery space is detected by the Toner Full Sensor. 1. Status of the waste toner recovery space is checked: ■ When the power is turned on. ■ When the front cover is opened and closed. ■ When paper exits the print engine. 2. "Transfer Roller is at End of Life" error message is generated when the toner full sensor detects the waste toner recovery space is full. 3. "Replace Transfer Roller " warning message is generated if the print count and the toner dispense time are counted and the total count exceeds 15,000 prints. 4. "Transfer Roller is at End of Life" error/ "Replace Transfer Roller " warning messages are reset if the toner full sensor does not detect a full waste toner recovery space when power is turned on, or the front cover is opened and closed. Theory of Operation 2-11
![](/manual_guide/products/xerox-6250n-service-manual-180e350/50.png)