Xerox 6250N Service Manual - Page 51
Toner Control, Toner Low Sensor, Toner Presence Control - reset
UPC - 095205770407
View all Xerox 6250N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Toner Control Toner Cartridge installation is detected by the Toner Present (CTG-In) Switch, and the presence of toner is detected by the Toner Low Sensor. These switches and sensors are provided for each toner color (CMYK), and detection is made for each individually. Toner Low Sensor The toner low sensor checks one color every 3.5 seconds, requiring 14 seconds to detect all four colors. The toner low sensor is attached to the Toner Cartridge Holder Assembly. It detects toner dispensed by the toner motor from the toner cartridge into the auger tube. The toner low sensor can make a false detection if toner has stuck to the surface of the sensor. To prevent this, a film attached near the auger in the toner cartridge holder assembly cleans the sensor surface whenever toner is dispensed. This film rotates with the auger as toner is dispensed, scraping toner off the toner low sensor surface. The toner low sensor may detect toner even if toner is not present or may not detect the toner even if toner is present, depending on the film position when the toner motor stops. This is avoided by the printer's internal toner presence control. Toner Presence Control 1. Checks for toner presence when the power is turned on, or after the front cover is opened and closed. Checks every 14 seconds when printing. 2. The "Toner Empty" warning is displayed when the counter on the Customer Replaceable Unit Monitor (CRUM) indicates that the toner is empty. 3. The "Toner Empty" error is displayed when the toner low sensor detects that toner is empty. 4. When a new toner cartridge is installed ("Toner Empty error" not being generated), toner is dispensed for 1.7 seconds. At the next toner control timing, if the toner low sensor detects toner present, the "Toner Full", "Toner Empty Warning", and "Toner Empty Error" are reset. When toner is dispensed and the toner low sensor detects toner present three or more times consecutively, the controller regards this status as "Toner Present". 5. If the toner low sensor does not detect toner present, toner will be dispensed for 1.7 seconds again 5 seconds later. If toner present is not detected after executing toner dispense three times and if toner cartridge dispense time shows 0, "Remove Ribbon From 'x' Cartridge" error is displayed. 2-12 Phaser 6250 Color Laser Printer Service Manual