Xerox 6250N Service Manual - Page 44
Print Modes, Printer Controls, Paper Size Control
UPC - 095205770407
View all Xerox 6250N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Print Modes There are three print modes: Draft mode, Enhanced mode, and Photo mode. These are based on the resolution (600 dpi or 2400 dpi) and, depending on the media type, can also be affected by process speed (full speed/half speed/one-third speed). ■ Draft mode: 600 X 600 dpi resolution. Used to check layout. Provides reduced toner usage. ■ Enhanced mode: 2400 X 600 dpi resolution. General purpose mode for crisp bright color prints. Recommended for most office use. It is the default mode ■ Photo mode: 2400 X 600 dpi resolution. Highest quality color print with very smooth color shades. When using photo paper or OHP, gloss is raised by setting the process speed to one-third. Printer Controls Paper Size Control The paper size selection is controlled by three paper size switches located in each paper tray slot. The switch condition is set by moving the paper guide in the tray. This in turn sets the plastic "fingers" on the side of the paper tray to a specific postion that activates the correct switch combination for the selected paper size. Paper Size Switches are indicated as SW1, SW2, and SW3 Paper Size LEGAL14" US FOLIO (LEGAL 13)" EXECUTIVE B5 A4 A5 (for reference only, supported in Tray 1 [MPT] only) LETTER No Tray Paper Size Switch SW1 SW2 SW3 ON ON ON ON OFF OFF ON ON OFF OFF ON ON ON OFF ON OFF ON OFF OFF OFF OFF OFF ON OFF Theory of Operation 2-5