Yamaha RX-A1010 Owners Manual - Page 138
Remote control, External devices cannot be controlled
View all Yamaha RX-A1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
Problem The files in the PC cannot be viewed or played back. The Internet radio cannot be played. Cause The files are not supported by this unit or the media server. The selected Internet radio station is currently not available. The selected Internet radio station broadcasts audio silence currently. Access to the network is restricted by the firewall settings of your network devices (router, etc). Remedy Use the file format supported by both this unit and the media server. For information about the file formats supported by this unit, see "Playing back music stored on PCs" (p.75). It may not be available to listen because there might be a network problem, or the station might be broadcasting in limited hour. Try the station later or select another station. Some Internet radio stations broadcast audio silence during particular periods of time in a day. Try the station later or select another station. Check the firewall settings of your network devices. The Internet radio can be played only when it passes through the port designated by each radio station. The port number is variable depending on radio station. Remote control Problem Cause Remedy Out of the operating range. Use the remote control in the operating range (p.5). The batteries are weak. Replace with new batteries. This unit cannot be controlled using the remote control. Direct sunlight or lighting is striking the remote control sensor of this unit. The remote control is set to control external devices. Adjust the lighting angle, or reposition this unit. Press SOURCE/RECEIVER to set the remote control to control this unit (the key lights up in orange). The remote control IDs of the main unit and remote control are not identical. Change the remote control ID of the main unit or remote control (p.120). External devices cannot be controlled using the remote control. The remote control is set to control this unit. The corresponding remote control code is not set properly. Press SOURCE/RECEIVER to set the remote control to control external devices (the key lights up in green). Set the remote control code again (p.123). Even if the remote control code is registered properly set, some products may not respond to the remote control. The batteries of the remote control of this unit and/or the external device are weak. Replace with new batteries. The remote control does not learn new functions. The distance between the two remote controls is not appropriate. The signal coding or modulation of the other remote control is not compatible with this remote control. Place the remote controls at a proper distance (p.125). Learning is impossible in this case. Memory capacity is full. Clear unnecessary assignments to free some memory space for the new functions (p.129). En 138