Yamaha RX-A1010 Owners Manual - Page 47
Measuring at one listening position (single measure), select Measure and press ENTER.
View all Yamaha RX-A1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
1 2 3 4 5 6 7 8 9 Automatic speaker setup SOURCE RECEIVER AV 1 2 3 5 6 7 AUDIO 1 2 3 PHONO MULTI DOCK TUNER USB [A] SCENE 1 2 3 4 V-AUX 4 NET [B] 4 PROGRAM MUTE VOLUME TOP MENU ON SCREEN POP-UP/MENU OPTION ENTER RETURN DISPLAY Cursor keys ENTER RETURN MODE PRESET INPUT MUTE CLASSICAL MOVIE TV TV VOL LIVE CLUB STEREO TV CH ENTERTAIN STRAIGHT PURE DIRECT Measuring at one listening position (single measure) When "Multi Position" is set to "No", follow the procedure below to make the measurement. • YPAO measurement is not performed correctly when any obstacles are in the room. • During the measuring process (about 3 minutes), keep stuff in the corners or remove it from the room. 1 To start the measurement, use the cursor keys to select "Measure" and press ENTER. The measurement will start in 10 seconds. Press ENTER again to start the measurement immediately. • To cancel the measurement, press RETURN. The following screen appears on the TV when the measurement finishes. 3 To save the measurement results, use the cursor keys to select "SAVE" and press ENTER. The corrected speaker settings are applied. • To finish the measurement without saving the result, select "CANCEL". 4 Disconnect the YPAO microphone from this unit. Now optimization of the speaker settings is complete. Caution • Since the YPAO microphone is sensitive to heat, do not place the microphone in any place where it will be subjected to direct sunlight or high temperatures (top of an AV equipment, etc). • If any error message (such as E-1) or warning message (such as W-1) appears, see "Error messages" (p.50) or "Warning messages" (p.51). • To check the measurement results, select "Result". For details, see "Checking the measurement results" (p.49). 2 Use the cursor keys to select "Save/Cancel" and press ENTER. En 47