Yamaha RX-A1010 Owners Manual - Page 19
Speaker connections, Speakers to be connected, Cables necessary for connection commercially available - power output
View all Yamaha RX-A1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
1 Speaker connections 2 3 4 5 6 7 8 9 ■ Connecting speakers Connect the speakers placed in your room to this unit. Caution • Remove the power cable of this unit from an AC wall outlet and turn off the subwoofer before connecting the speakers. • Be careful that the core of the speaker cable does not touch anything or come into contact with the metal areas of this unit. This may damage this unit or the speakers. If the speaker cables short circuit, "CHECK SP WIRES" will appear on the front display when this unit is turned on. Speakers to be connected Room Speaker type Abbr. Speaker system (the number of channels) 9+2 9 7 5 2 Power Amp Assign (p.104) Front (L) Front (R) Main zone Center Surround (L) Surround (R) Surround back (L) Surround back (R) Front presence (L) Front presence (R) Rear presence (L) Rear presence (R) ●●●● ●●●● ●●●● ● {*1 {*3 ● {*1 {*3 ● ● {*4 ● ● {*4 ● {*2 ● {*2 Basic (default) If you have 9 speakers, use two of them as surround back speakers (*1) or rear presence speakers (*2). If you have 7 speakers, use two of them as surround back speakers (*3) or front presence speakers (*4). Cables necessary for connection (commercially available) Speaker cables (x the number of speakers) + + - - Audio pin cable (2 for connecting 2 subwoofers) Connection diagram Refer to the following diagram and connect the speakers to this unit. AUDIO 3 AUDIO 4 MULTI CH INPUT CENTER ZONE OUT PRE OUT (SINGLE) (FRONT) 1 2 This unit (rear) FRONT SURROUND SUR. BACK SUBWOOFER ZONE 2 ZONE 3 FRONT (REAR) SURROUND SUR. BACK SUBWOOFER CENTER R SURROUND L R SURROUND BACK L SPEAKERS ZONE 2/ZONE 3/R.PRESENCE R EXTRA SP2 L CENTER R FRONT L ZONE 2/ZONE 3/F.PRESENCE/ BI-AMP R EXTRA SP1 L SINGLE SPEAKER IMPEDANCE • You can also connect up to 2 subwoofers (with built-in amplifier) to this unit. When using 2 subwoofers, configure the "SWFR Layout" setting (p.106) in the "Setup" menu after connecting the power cable to an AC wall outlet. • To use an external power amplifier (Hi-Fi amplifier, etc.) to enhance speaker output, see "Connecting an external power amplifier" (p.27). • When using only one surround back speaker, connect it to the SINGLE jack (L side). En 19