Yamaha RX-A1010 Owners Manual - Page 60

SOURCE RECEIVER AV 1 2 3 5 6 7 AUDIO 1 2 3 PHONO MULTI DOCK TUNER USB [A] SCENE 1 2 3 4 V-AUX 4 NET [B] 4 TUNER PROGRAM MUTE VOLUME TOP MENU ON SCREEN POP-UP/MENU OPTION ENTER RETURN DISPLAY MODE MODE PRESET INPUT MUTE CLASSICAL MOVIE TV TV VOL LIVE CLUB STEREO TV CH ENTERTAIN STRAIGHT PURE DIRECT PRESET SUR. DECODE ENHANCER PARTY HDMI OUT INFO MEMORY FM AM 1 2 3 TUN./ CH 4 5 6 7 8 9 SLEEP 10 0 ENT LEVEL ZONE SETUP MEMORY FM AM TUN./CH Numeric keys ENT Listening to FM/AM radio You can tune into a radio station by specifying its frequency or selecting from registered radio stations. • The radio frequencies differ depending on the country or region where the unit is being used. The explanation of this section uses a display with frequencies used in U.K. and Europe models. • If you cannot have a good reception on the radio, adjust the direction of the FM/ AM antennas. Setting the frequency steps (Asia and General models only) At the factory, the frequency step setting is set to 50 kHz for FM and 9 kHz for AM. Depending on your listening environment, set the frequency steps to 100 kHz for FM and 10 kHz for AM. 1 Set this unit to standby mode. 2 When holding down STRAIGHT on the front panel, press MAIN ZONE . MAIN ZONE STRAIGHT Selecting a frequency for reception 1 Press TUNER to select "TUNER" as the input source. 2 Press FM or AM to select a band. DOCK TAG HD STEREO TUNED PRE AMP PARTY ZONE ZONE ZONE IN OUT 1 OUT 2 2 3 4 SLEEP HD 3 FM 87.50MHz MUTE VOLUME ADAPTIVE DRC PL L C R PR SL SW1 SW SW2 SR PL SBL SB SBR PR 3 Use the following keys to set a frequency. TUN./CH: Increase/decrease the frequency. Hold down the key for about a second to search the station automatically. Numeric keys: Enter a frequency directly. For example, to select 98.50 MHz, press "9", "8", "5" and "0" (or ENT). DOCK TAG HD STEREO TUNED PRE AMP PARTY ZONE ZONE ZONE IN OUT 1 OUT 2 2 3 4 SLEEP HD 3 FM 98.50MHz MUTE VOLUME ADAPTIVE DRC PL L C R PR SL SW1 SW SW2 SR PL SBL SB SBR PR "TUNED" lights up when a signal is received from a radio station. "STEREO" also lights up when a stereo signal is received. PROGRAM 3 Press PROGRAM repeatedly to select "TUNER FRQ STEP". DOCK TAG TUNER HD STEREO TUNED PRE AMP PARTY ZONE ZONE ZONE IN OUT 1 OUT 2 2 3 4 SLEEP HD 3 FRQ STEP FM50/AM9 4 Press STRAIGHT to select "FM100/AM10". 5 Press MAIN ZONE to set this unit to standby mode and turn it on again. • "Wrong Station!" appears when you enter a frequency that is out of receivable range • You can switch between "Stereo" (stereo) and "Mono" (monaural) for FM radio reception by pressing MODE. When signal reception for FM radio station is unstable, switching to "Mono" may improve it. En 60