Yamaha RX-A1010 Owners Manual - Page 20
Connecting speaker cables, Connecting the subwoofer, Using a banana plug - canada
View all Yamaha RX-A1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
1 Speaker connections 2 3 4 5 6 7 8 9 ❑ Connecting speaker cables Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent confusion, connect the black wire to the negative and the other wire to the positive. a Remove approximately 10 mm of insulation from the ends of the speaker cable, and twist the bare wires of the cable together firmly. b Loosen the speaker terminal. c Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the terminal. d Tighten the terminal. + (red) b + FRONT c - a d - (black) Using a banana plug (Canada, China, Australia and General models only) a Tighten the speaker terminal. b Insert a banana plug into the end of the terminal. a+ FRONT Banana plug b ❑ Connecting the subwoofer Use an audio pin cable to connect the subwoofer. Audio pin cable PRE OUT (SINGLE) (FRONT) 1 SURRUND 2 SUR. BACK SU(BRWEOAORF)ER CENTER CENTER FRONT En 20