2010 Suzuki Kizashi Owner's Manual - Page 35
2010 Suzuki Kizashi Manual
Page 35 highlights
BEFORE DRIVING How to stop the alarm Should the alarm be triggered accidentally, change the ignition mode to "ON" by pressing the engine switch. The alarm will then stop. NOTE: • Even after the alarm has stopped, if you lock the doors using the keyless start system remote controller or by pushing the request switch, the theft deterrent alarm system will be rearmed with a delay of about 20 seconds. • If you disconnect the battery while the theft deterrent alarm system is in the armed condition or the alarm is actually in operation, the alarm will be triggered or re-triggered when the battery is then reconnected, although, in the latter case, the alarm remains stopped for the period between disconnection and reconnection of the battery. • Even after the alarm has stopped at the end of the predetermined operation time, it will be triggered again if any door is opened without disarming the theft deterrent alarm system. Checking whether the alarm has been triggered during parking If the alarm was triggered due to an unauthorized entry into the vehicle and you then change the ignition mode to "ON" by pressing the engine switch, the theft deterrent light will flash rapidly for about 8 seconds and a buzzer will beep 4 times during this period. If this happens, check whether your vehicle has been broken into while you were away from it. Enabling and disabling the theft deterrent alarm system The theft deterrent alarm system can be either "enabled" or "disabled". When enabled (factory setting) When the system is enabled, it causes the hazard warning lights to flash for about 40 seconds if any of the alarm trigger conditions is met. The system also causes the interior buzzer to beep intermittently for about 10 seconds, which is followed by intermittent sounding of the horn for about 30 seconds. *The theft deterrent light continues to flash during this time. When disabled When the system is disabled, it stays disarmed even if you perform any system arming operation. How to switch the state of the theft deterrent alarm system You can switch the theft deterrent alarm system from the enabled state to the disabled state, and vice versa, using the following method. (2) (3) (1) EXAMPLE 57L21020 (2) UNLOCK (3) LOCK (5) 4 times (4) EXAMPLE 57L21021 2-16