2010 Suzuki Kizashi Owner's Manual - Page 36

BEFORE DRIVING 1) With the ignition mode changed to "ON" by pressing the engine switch, close all the doors as well as the engine hood and the trunk lid and push the unlock end (backward end) of the power door locking switch (1) of the driver's door. Turn the knob control on the lighting control lever to the OFF position (4). NOTE: All operations included in the following steps 2) and 3) must be completed within 15 seconds. 2) Turn the knob control on the lighting control lever to the position (5) and then to the OFF position (4). Repeat this operation 4 times with the control finally set to the OFF position. 3) Push the lock end (forward end) of the power door lock switch (1) to lock the doors, and then the unlock end (backward end) to unlock the doors. Repeat these operations 3 times and finally push the lock end of the switch. Every time you perform the series of the above steps, the state of the theft deterrent alarm system changes from the currently selected one to the other. You can check whether the system is enabled or disabled by the number of interior buzzer beeps at the end of the procedure as follows. System state Disabled Enabled Number of beeps Windows Power Window Controls Driver's side EXAMPLE (1) Once (4) 4 times (2) (5) 57L21024 NOTE: • You cannot disable the theft deterrent alarm system while it is in the armed condition. • If you fail to complete the operations in step 2) and 3) within 15 seconds, perform the procedure again from the beginning. • Make sure all doors are closed when performing the above procedure. The power windows can be operated when the ignition mode is changed to "ON" by pressing the engine switch. The driver's door has switches (1), (2), (4), (5), to operate the driver's window, the front passenger's window, the rear left window and the rear right window, respectively. 2-17