2010 Suzuki Kizashi Owner's Manual - Page 93

BEFORE DRIVING Malfunction Indicator Light CAUTION Continuing to drive the vehicle when the malfunction indicator light is on or blinking can cause permanent damage to the vehicle's emission control system, and can affect fuel economy and driveability. 65D530 54G343 Low Fuel Warning Light Your vehicle has a computer-controlled emission control system. A malfunction indicator light is provided on the instrument panel to indicate when it is necessary to have the emission control system serviced. The malfunction indicator light comes on when you press the engine switch to change the ignition mode to "ON" to let you know the light is working and goes out when the engine is started. If the malfunction indicator light comes on or blinks when the engine is running, service to the emission control system is necessary. Bring the vehicle to an authorized SUZUKI dealer to have the emission control system serviced right away and avoid hard acceleration until the service is performed. Also, if the light comes on, there may be something wrong with the continuously variable transaxle system. Have the system inspected by an authorized SUZUKI dealer. NOTE: If the fuel filler cap is not installed fully, the electrical system gets wet (such as by driving through a deep puddle of water) or the fuel tank gets nearly empty, the malfunction indicator light may come on. If so, the light will go off after driving a few times after the fuel filler cap is installed fully, the electrical system dries out or the fuel tank is filled. If this light comes on, fill the fuel tank immediately. When this light comes on, a ding sounds once to remind you to fill the fuel. If you do not fill the fuel, a ding sounds every time you press the engine switch to change the ignition mode to "ON". NOTE: The activation point of this light varies depending on road conditions (for example, slope or curve) and driving conditions because of fuel moving in the tank. 2-74