2010 Suzuki Kizashi Owner's Manual - Page 95

BEFORE DRIVING Intelligent All Wheel Drive (i-AWD) Indicator Light (if equipped) Conditions for D.R.L. system operation 1) The engine is running. 2) The parking brake is released. 3) The headlights are off. • The light does not go out in about 2 seconds after changing the ignition mode to "ON" by pressing the engine switch. Transaxle Warning Light (if equipped) Immobilizer/Keyless Start System Warning Light 57L30044 When the 2WD/i-AWD switch is in the "iAWD" mode with the engine switch in the "ON" mode, the light comes on and stays on. For details, refer to "Using the 2WD/i-AWD Switch" in the "OPERATING YOUR VEHICLE" section. 80J219 80JM122 Daytime Running Light (D.R.L.) Indicator Light (if equipped) This light comes on when you press the engine switch to change the ignition mode to "ON" if there is any problem with the continuously variable transaxle (CVT). • The light should normally come on when the ignition mode is changed to "ON" by pressing the engine switch and stay on for about 2 seconds before going out. NOTE: The following conditions may indicate some problem with the CVT system. If any of these conditions occurs, have your vehicle inspected by an authorized SUZUKI dealer. • The light comes on while driving. • The light does not come on even when the ignition mode is changed to "ON" by pressing the engine switch. When you press the engine switch to change the ignition mode to "ON", the light comes on briefly so you can check that the light is working. If this light stays on, there is a problem with the system. This light flashes if you press the engine switch while the system is not sensing the remote controller. For details, refer to "Immobilizer System" in this section. i-AWD Warning Light (if equipped) 60B245 With the D.R.L. system, the headlights light, but are dimmer than the low beam, when the following three conditions are all met. Whenever the D.R.L. system is operating, the D.R.L. indicator light remains on. 57L30042 When you press the engine switch to change the ignition mode to "ON", the light 2-76