Brother International Isodore„ Innov-ís 5000 Users Manual - English - Page 13

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS NAMES OF MACHINE PARTS AND THEIR FUNCTIONS The names of the various parts of the sewing machine and their functions are described below. Before using the sewing machine, carefully read these descriptions to learn the names of the machine parts. Machine ■ Front View ■ Right-side/Rear View aa on nm ml b lk c j a ih d f k i c ji e kj m b g hg fe dc ed gf a Top cover Open the top cover to thread the machine and wind the bobbin. b Thread cutter Pass the threads through the thread cutter to cut them. c Thread take-up lever check window Look through the window to check the upper thread passing through in it. d Flat bed attachment with accessory compartment Store presser feet and bobbins in the accessory compartment of the flat bed attachment. When sewing cylindrical pieces, remove the flat bed attachment. e Operation buttons (6 buttons) and sewing speed controller Use these buttons and the slide to operate the sewing machine. f Knee lifter slot Insert the knee lifter into the slot. g Knee lifter Use the knee lifter to raise and lower the presser foot. h LCD (liquid crystal display) Settings for the selected stitch and error messages appear in the LCD. i Thread guide plate Pass the thread around the thread guide plate when threading upper thread. j Spool cap Use the spool cap to hold the spool in place. k Spool pin Place a spool of thread on the spool pin. l Bobbin winder Use the bobbin winder when winding the bobbin. m Supplemental spool pin Use this spool pin to wind the bobbin thread, or to sew with the twin needle. n Thread guide for bobbin winding Pass the thread around this thread guide when winding the bobbin thread. o Pretension disk Pass the thread around the pretension disk when winding the bobbin thread. h l a Handle Carry the sewing machine by its handle when transporting the machine. b Handwheel Turn the handwheel toward you to raise and lower the needle. The wheel should be turned toward the front of the machine. c Embroidery card slot Insert the embroidery cards (sold separately) into the embroidery card slot. d USB port connector for media In order to send patterns from/to USB media, plug the USB media directly into the USB port connector. e USB port connector for computer In order to import/export patterns between a computer and the machine, plug the USB cable into the USB port connector. f Touch pen holder Use the touch pen holder to hold the touch pen when not in use. g Main power switch Use the main power switch to turn the sewing machine ON and OFF. h Jack connector Insert the power cord into the connector jack. i Feed dog position switch Use the feed dog position switch to lower the feed dogs. j Presser foot lever Raise and lower the presser foot lever to raise and lower the presser foot. k Air vent The air vent allows the air surrounding the motor to circulate. Do not cover the air vent while the sewing machine is being used. l Foot controller with retractable cord Depress the foot controller to control the speed of the machine. m Foot controller jack Insert the foot controller plug into its jack on the machine. 1