Brother International Isodore„ Innov-ís 5000 Users Manual - English - Page 69
Dart Seam, Gathering
View all Brother International Isodore„ Innov-ís 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Dart Seam SEWING THE STITCHES e Iron the dart to one side so that it is flat. a Select and attach presser foot "J". b Sew dart a reverse stitch at the beginning and then sew from the wide end of the to the other end without stretching the fabric. * If automatic reinforcement stitching is preset, a reinforcement stitch will automatically be sewn at the beginning of sewing. Gathering a Use on waists of skirts, sleeves of shirts, etc. a Select a straight foot "J". stitch and attach presser 3 Utility Stitches a Basting c Cut the thread at (approx. 1-15/16 the end leaving 50 mm inches), and then tie both ends together. * Do not sew a reverse stitch at the end. d Insert the ends with a needle. of the thread into the dart b Set the stitch length to 4.0 mm (approx. 3/16 inch) and the thread tension to approximately 2.0 (weaker tension). * If you press after pressing , the stitch length will be set automatically to 4.0 mm (approx. 3/16 inch) and the thread tension will be automatically set to 2.0. c Pull the bobbin and upper threads out by 50 mm (approx. 1-15/16 inches) (see page 23). a b c a Upper thread b Bobbin thread c About 50 mm (approx. 1-15/16 inches) 57