Brother International Isodore„ Innov-ís 5000 Users Manual - English - Page 45

CHANGING THE PRESSER FOOT Attaching the Walking Foot d Lower the presser foot lever. screw, and tighten the screw Insert the securely with the screwdriver. The walking foot holds the fabric between the presser foot and the feed dogs to feed the fabric. This enables you to have better fabric control 1 when sewing difficult fabrics (such as quilting or velvet) or fabrics that slip easily (such as vinyl cloth, leather, or synthetic leather). Getting Ready Note • When sewing with the walking foot, sew at medium to low speeds. Memo • The walking foot can only be used with straight or zigzag stitch patterns. Reverse stitches cannot be sewn with the walking foot. Only select straight or zigzag stitch patterns with reinforcement stitches. a Follow the steps in "Removing Foot" on the previous page. the Presser b Loosen the screw of the presser foot to remove the presser foot holder. holder CAUTION • Use the screwdriver to tighten the screw securely. If the screw is loose, the needle may strike the presser foot and cause injury. • Be sure to turn the handwheel toward the front of the machine to check that the needle does not strike the presser foot. If the needle strikes the presser foot, injury may result. c Set the so that operation lever of the walking the needle clamp screw is set foot between the fork, and position the walking foot on the presser foot bar. ac b d a Operation lever b Needle clamp screw c Fork d Presser foot bar 33