Brother International Isodore„ Innov-ís 5000 Users Manual - English - Page 15
Operation Buttons, Included Accessories, CAUTION
View all Brother International Isodore„ Innov-ís 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Operation Buttons NAMES OF MACHINE PARTS AND THEIR FUNCTIONS Included Accessories Pull the top of the flat bed attachment to open the accessory compartment. a a "Start/Stop" button Press this button and the machine will sew a few stitches at a slow speed and then begin sewing at the speed set by the sewing speed controller. Press the button again to stop the machine. Hold the button in to sew at the machine's slowest speed. The button changes color according to the machine's operation mode. Green: Red: the machine is ready to sew or is sewing. the machine cannot sew. b "Reverse/Reinforcement Stitch" button Use this button to sew reinforcement stitches at the beginning and end of sewing. Press this button, and the machine sews 3 stitches in the same spot and stops automatically. For straight and zigzag stitch patterns that take reverse stitches, the machine will sew reverse stitches at low speed only while holding down the "Reverse/Reinforcement Stitch" button (the stitches are sewn in the opposite direction). c "Needle Position" button Use this button when changing sewing direction or for detailed sewing in small areas. Press this button to raise or lower the needle position. Press the button twice to sew a single stitch. d "Thread Cutter" button Press this button after sewing to automatically trim the excess thread. e "Presser Foot Lifter" button Press this button to lower the presser foot and apply pressure to the fabric. Press this button again to raise the presser foot. f Sewing Speed controller Use this controller to adjust the sewing speed. Move the slide to the left to sew at slower speeds. Move the slide to the right to sew at higher speeds. Beginners should sew at a slow speed. g "Automatic Threading" button Use this button to automatically thread the needle. CAUTION • Do not press the thread cutter button after the threads have already been cut. Otherwise, the needle may break, the threads may become tangled, or damage to the machine may occur. b c a Storage space b Presser foot storage space c Presser foot storage space Included Accessories 31-34 are contained in the embroidery unit carrying case. To open the embroidery unit carrying case, unhook the two latches on the case. To re-hook the latches and securely close the case, press on the latches until each of them clicks. a a Latches 3