Brother International MFC 7440N Users Manual - English - Page 125
Transferring your faxes or Fax Journal report, Init Unable XX - toner life end
UPC - 012502620631
View all Brother International MFC 7440N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Troubleshooting and routine maintenance Error Message Scan Unable XX Toner Life End Toner Low Cause Action The machine has a mechanical problem. Do one of the following: (MFC-7440N only) See Transferring your faxes or Fax Journal report on page 111 before disconnecting the machine so you will not lose any important messages. Then, disconnect the machine from the power for several minutes and then reconnect it. (MFC-7840W only) Disconnect the machine from the power for several minutes, then reconnect it. (The machine can be turned off for approximately 4 days without losing faxes stored in the memory. See Transferring your faxes or Fax Journal report on page 111.) The drum unit and toner cartridge assembly may have been installed improperly, or the toner cartridge is used up and printing is not possible. Do one of the following: Re-install the toner cartridge and drum unit assembly. Replace the empty toner cartridge with a new one. (See Replacing a toner cartridge on page 126.) If the LCD shows Toner Low, you can still print; however, the machine is telling you that the toner cartridge is near the end of its life and the toner will soon run out. Order a new toner cartridge now. Transferring your faxes or Fax Journal report B If the LCD shows: Init Unable XX Print Unable XX Scan Unable XX We recommend transferring your faxes to another fax machine or to your PC. (See Transferring faxes to another fax machine on page 112 or Transferring faxes to your PC on page 112.) You can also transfer the Fax Journal report to see if there are any faxes you need to transfer. (See Transferring Fax Journal report to another fax machine on page 112.) Note If there is an error message on the machine's LCD, after the faxes have been transferred, disconnect the machine from the power source for several minutes, and then reconnect it. B 111