Cisco CSS 11501 Getting Started Guide - Page 26
Configuring the Ethernet Management Port
UPC - 746320761664
View all Cisco CSS 11501 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Booting the CSS for the First Time Chapter 1 Booting, Logging In, and Getting Started After you receive the software license key, use the license command to enter the license key. At the prompt, enter the license key. To install the Enhanced feature set license key: 1. Log in to the CSS and enter the license command. # license 2. Enter the 12-digit Enhanced feature set software license key. For example: Enter the Software License Key (q to quit): nnnnnnnnnnnn The Enhanced feature set license key is now properly installed and the feature set is activated. Note After you enter the software license key for the Proximity Database software option, you must reboot the CSS for the license key to take effect. Configuring the Ethernet Management Port Once you enter a valid license key at the boot prompt, the CSS displays the following message and prompt: Use the Ethernet management port IP address to access the Content Services Switch for configuration and management only. This port does not route traffic and is not associated with VLAN circuits. The current address setting (0.0.0.0) disables the Ethernet Management port. Do you wish to configure a valid address for the Ethernet management port [y/n]? Cisco Content Services Switch Getting Started Guide 1-4 OL-6037-01