Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1093

Hello due in 00:00:08 Neighbor Count is 3, Adjacent neighbor count is 2 Adjacent with neighbor 192.168.253.5 (Designated Router) Adjacent with neighbor 192.168.253.3 (Backup Designated Router) Loopback 0 is up, line protocol is up Internet Address 192.168.253.2/32, Area 0.0.0.1 Process ID 1, Router ID 192.168.253.2, Network Type LOOPBACK, Cost: 1 Loopback interface is treated as a stub Host. FTOS> show ip ospf neighbor Display the OSPF neighbors connected to the local router. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters show ip ospf process-id neighbor process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Command Modes Command History EXEC Privilege Version 8.3.11.1 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on the Z9000. Introduced on the S4810. Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show ip ospf process-id neighbor command shown in the Example below. Item Neighbor ID Pri State Dead Time Address Interface Area Description Displays the neighbor router ID. Displays the priority assigned neighbor. Displays the OSPF state of the neighbor. Displays the expected time until FTOS declares the neighbor dead. Displays the IP address of the neighbor. Displays the interface type slot/port information. Displays the neighbor's area (process ID). 1093