Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1482

Usage Information The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. A system message appears after you enter or delete the virtual-address command. To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual address with the same IP address as the interface's primary IP address and change the priority of the VRRP group to 255. You can ping the virtual addresses configured in all VRRP groups. vrrp delay minimum Set the delay time for VRRP initialization after an interface comes up. Z-Series, S4810 Syntax Parameters vrrp delay minimum seconds seconds Enter the number of seconds for the delay for VRRP initialization after an interface becomes operational. The range is 0 to 900 (0 indicates no delay). Defaults Command Modes Command History 0 INTERFACE Version 9.0.0.0 Version 8.3.8.0 Introduced on the Z9000. Introduced on the S4810. Usage Information This command applies to a single interface. When used in conjunction with the vrrp delay reload CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the vrrp delay minimum is 300: • When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured for VRRP. • When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface. Related Command vrrp delay reload - sets the delay time for VRRP initialization after a system reboot. vrrp delay reload Set the delay time for VRRP initialization after a system reboot. Z-Series, S4810 Syntax Parameters vrrp delay reload seconds seconds Enter the number of seconds for the delay. The range is 0 to 900 (0 indicates no delay). 1482