Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1100

Parameters Command Modes Command History Usage Information Example process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. • EXEC • EXEC Privilege Version 9.1(0.0) Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Deprecated command on the S4810 and Z9000. Introduced on the S4810. Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. The following describes the show ip ospf process-id virtual-links command shown in the Example below. Items "Virtual Link..." "Run as..." "Transit area..." "Transmit Delay..." "Timer intervals..." "Hello due..." "Adjacency State..." Description This line specifies the OSPF neighbor to which the virtual link was created and the link's status. This line states the nature of the virtual link. This line identifies the area through which the virtual link was created, the interface used, and the cost assigned to that link. This line displays the transmit delay assigned to the link and the State of the OSPF neighbor. This line displays the timer values assigned to the virtual link. The timers are Hello is hello-interval, Dead is dead-interval, Wait is transmit-delay, and Retransmit is retransmit-interval. This line displays the amount of time until the next Hello packet is expected from the neighbor router. This line displays the adjacency state between neighbors. FTOS#show ip ospf 1 virt Virtual Link to router 192.168.253.5 is up Run as demand circuit Transit area 0.0.0.1, via interface GigabitEthernet 13/16, Cost of using 2 Transmit Delay is 1 sec, State POINT_TO_POINT, Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Hello due in 00:00:02 FTOS# 1100