Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 794

Usage Information pre-Version 6.1.1.0 Introduced on the E-Series. This command is available for physical interfaces and port-channel interfaces on the E-Series. NOTE: This command is not supported on default VLAN (the default vlan-id command). ip route Assign a static route to the switch. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters ip route vrf {vrf instance} destination mask {ip-address | interface [ip-address]} [distance] [permanent] [tag tag-value] To delete a specific static route, use the no ip route destination mask {address | interface [ip-address]} command. To delete all routes matching a certain route, use the no ip route destination mask command. vrf name destination mask ip-address interface (OPTIONAL) E-Series Only: Enter the keyword vrf followed by the VRF Instances name to tie the static route to the VRF instance. Enter the IP address in dotted decimal format of the destination device. Enter the mask in slash prefix formation (/x) of the destination device's IP address. Enter the IP address in dotted decimal format of the forwarding router. Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a loopback interface, enter the keyword loopback followed by a number from zero (0) to 16383. • For the null interface, enter the keyword null followed by zero (0). • For a Port Channel interface, enter the keyword portchannel followed by a number. For the C-Series and SSeries, the range is 1 to 128. For the E-Series, the range is 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the sonet followed by the slot/port information. 794