Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 953

show fefd View FEFD status globally or on a specific interface. E-Series, Z-Series, S4810 Syntax Parameters show fefd [interface] interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/ port information. Command Modes Command History Usage Information • EXEC • EXEC Privilege Version 8.3.11.1 Version 8.3.12.0 Legacy E-Series command. Introduced on the Z9000. Introduced on the S4810. The following describes the show fefd command shown in the Example below. Field Interface Mode Interval State Description Displays the interfaces type and number. Displays the mode (aggressive or normal) or NA if the interface contains fefd reset in its configuration. Displays the interval between FEFD packets. Displays the state of the interface and can be one of the following: • bi-directional (interface is up and connected and ing neighbor's echoes). • err-disabled (only found when the FEFD mode is aggressive and when the interface has not n its neighbor's echoes for 3 953