Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 678

Example (VLT) NOTE: The asterisk (*) after the port channel number (Po 2) highlighted in the Example below indicates the port channel is VLT, that the local VLT port channel is down and the remote VLT port is up. FTOS#show ip igmp groups Total Number of Groups: 5 IGMP Connected Group Membership Group Address Interface Mode Uptime Expires Last Reporter 225.0.0.0 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* 225.0.0.1 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* 225.0.0.2 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* 225.0.0.3 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* 225.0.0.4 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* show ip igmp interface View information on the interfaces participating in IGMP. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters show ip igmp interface [interface] interface (OPTIONAL) Enter the interface type and slot/port information: • For a 100/1000 Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For a Port Channel interface, enter the keywords portchannel followed by a number. For the C-Series and SSeries, the range is 1 to 128. For the E-Series, the range is 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN interface enter the keyword vlan followed by a number from 1 to 4094. 678