Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1114

ipv6 ospf dead-interval Set the time interval since the last hello-packet was received from a router. After the time interval elapses, the neighboring routers declare the router down. C-Series, E-Series, Z-Series, S4810 Syntax ipv6 ospf dead-interval seconds To return to the default time interval, use the no ipv6 ospf dead-interval command. Parameters seconds Enter the time interval in seconds. Range: 1 to 65535 seconds. Defaults Command Modes Command History Usage Information Related Commands 40 seconds (Ethernet). INTERFACE Version 9.1.(0.0) Version 7.8.1.0 Version 7.4.1.0 Introduced on the S4810 and Z9000. Added support for C-Series. Introduced on the E-Series. By default, the dead interval is four times longer than the default hello-interval. ipv6 ospf hellointerval Specify the time interval between hello packets. ipv6 ospf encryption Configure an IPsec encryption policy for OSPFv3 packets on an IPv6 interface. E-Series TeraScale, Z-Series, S4810 Syntax Parameters ipv6 ospf encryption {null | ipsec spi number esp encryptionalgorithm [key-encryption-type] key athentication-algorithm [key-encryption-type] key}} null ipsec spi number esp encryptionalgorithm Causes an encryption policy configured for the area to not be inherited on the interface. Security Policy index (SPI) value that identifies an IPsec security policy. Range: 256 to 4294967295. Encryption algorithm used with ESP. Valid values are: 3DES, DES, AES-CBC, and NULL. For AES-CBC, only the AES-128 and AES-192 ciphers are supported. 1114