Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1099

00:00:09.111 LSA id: 3.3.3.3 Type: 1 Adv Rtid: 3.3.3.3 Expiry time: 00:00:23.96 FTOS# show ip ospf topology Display routers in directly connected areas. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax show ip ospf process-id topology Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Defaults Command Modes none • EXEC • EXEC Privilege Command History Version 8.3.11.1 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on the Z9000. Introduced on the S4810. Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series and E-Series. Usage Information Example Use this command to isolate problems with inter-area and external routes. In OSPF inter-area and external routes are calculated by adding LSA cost to the cost of reaching the router. If an inter-area or external route is not of correct cost, the display can determine if the path to the originating router is correct or not. FTOS#show ip ospf 1 topology Router ID 3.3.3.3 1.1.1.1 FTOS# Flags Cost E/B/-/ 1 E/-/-/ 1 Nexthop 20.0.0.3 10.0.0.1 Interface Area Gi 13/1 0 Gi 7/1 1 show ip ospf virtual-links Display the OSPF virtual links configured and is useful for debugging OSPF routing operations. If no OSPF virtual-links are enabled on the switch, no output is generated. C-Series, E-Series, S-Series Syntax show ip ospf process-id virtual-links NOTE: This command was deprecated. 1099