Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1483

Defaults Command Modes Command History Usage Information Related Command 0 INTERFACE Version 9.0.0.0 Version 8.3.8.0 Introduced on the Z9000. Introduced on the S4810. This command applies to all the VRRP configured interfaces on a system. When used in conjunction with the vrrp delay minimum CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the vrrp delay minimum is 300: • When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured for VRRP. • When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface. You must save the configuration and reload the system for the delay timers to take effect. vrrp delay minimum - sets the delay time for VRRP initialization after a line card reboot. vrrp-group Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters vrrp-group vrrp-id vrrp-id Enter a number as the group ID. The range is 1 to 255. Defaults Command Modes Command History Not configured. INTERFACE Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Related Command The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. virtual-address - assigns up to 12 virtual IP addresses per VRRP group. 1483