Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 381

Parameters Defaults Command Modes Command History Usage Information Related Commands ip-address mask route-map mapname Enter an IP address in dotted decimal format of the network. Enter the mask of the IP address in the slash prefix length format (for example, /24). The mask appears in command outputs in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Not configured. ROUTER BGP Version 8.3.11.1 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. FTOS software resolves the network address configured by the network command with the routes in the main routing table to ensure that the networks are reachable using non-BGP routes and non-default routes. redistribute - redistributes routes into BGP. network backdoor Specify this IGP route as the preferred route. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax network ip-address mask backdoor To remove a network, use the no network ip-address mask backdoor command. Parameters ip-address Enter an IP address in dotted decimal format of the network. 381