Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1452

FTOS# M Gi 13/5 vlan-stack dot1p-mapping Map C-Tag dot1p values to a S-Tag dot1p value. C-Tag values may be separated by commas and dashed ranges are permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration in case of conflicts. C-Series, S-Series, Z-Series, S4810 Syntax Parameters Defaults Command Modes Command History vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value c-tag-dot1p value sp-tag-dot1p value Enter the keyword c-tag-dot1p followed by the customer dot1p value that will be mapped to a service provider do1p value. The range is 0 to 7. Enter the keyword sp-tag-dot1p followed by the service provider dot1p value. The range is 0 to 7. none INTERFACE Version 8.3.7.0 Version 8.3.1.0 Introduced on the S4810. Introduced on the C-Series and S-Series. vlan-stack protocol-type Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN tag). If you do not configure this command, FTOS assigns the value 0x9100. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters vlan-stack protocol-type number number Enter the hexadecimal number as the stackable VLAN tag. • On the E-Series: FTOS accepts the most significant byte (MSB) and then appends zeros for the least significant byte (LSB). The range is 0 to FF. • On the C-Series and S-Series: You may specify both bytes of the 2-byte S-Tag TPID. The range is 0 to FFFF. The default is 9100. 1452