Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 674

ip igmp ssm-map Use a statically configured list to translate (*,G) memberships to (S,G) memberships. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters ip igmp ssm-map std-access-list source-address Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G) state, use the ip igmp ssm-map std-access-list source-address command. std-access-list source-address Specify the standard IP access list that contains the mapping rules for multicast groups. Specify the multicast source address to which the groups are mapped. Command Modes Command History CONFIGURATION Version 8.3.11.1 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the Z9000. Introduced on the S4810. Introduced on the C-Series and S-Series. Introduced on the E-Series. Usage Information Related Commands Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups. You may not use extended access lists with this command. When you configure a static SSM map and the router cannot find any matching access lists, the router continues to accept (*,G) groups. ip access-list standard - creates a standard access list to filter based on IP address. ip igmp static-group Configure an IGMP static group. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters ip igmp static-group {group address [exclude [source address]] | [include {source address}]} To delete a static address, use the no ip igmp static-group {group address [exclude [source address]] | [include {source address}]} command. group address Enter the group address in dotted decimal format (A.B.C.D). 674