Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1133

ip pim dr-priority Change the designated router (DR) priority for the interface. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters ip pim dr-priority priority-value To remove the DR priority value assigned, use the no ip pim dr-priority command. priority-value Enter a number. Preference is given to larger/higher number. The range is 0 to 4294967294. The default is 1. Defaults Command Modes Command History 1 INTERFACE Version 8.3.11.1 Version 8.3.7.0 Version 8.1.1.0 Version 7.8.1.0 Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series on port-channels and the S-Series. Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces contain the same designated router priority value, the interface with the largest interface IP address becomes the designated router. ip pim join-filter Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM-SM router from creating state based on multicast source and/or group. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters ip pim join-filter ext-access-list {in | out} To remove the access list, use the no ip pim join-filter ext-access-list {in | out} command. ext-access-list in out Enter the name of an extended access list. Enter this keyword to apply the access list to inbound traffic. Enter this keyword to apply the access list to outbound traffic. Defaults Command Modes none INTERFACE 1133