Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 394

show ip bgp dampened-paths View BGP routes that are dampened (non-active). C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Command Modes show ip bgp [ipv4 unicast] dampened-paths • EXEC • EXEC Privilege Command History Version 8.3.11.1 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information The following describes the show ip bgp damp command shown in the Example below. Field Description Network Displays the network ID to which the route is dampened. From Displays the IP address of the neighbor advertising the dampened route. Reuse Displays the hour:minutes:seconds until the dampened route is available. Path Lists all the ASs the dampened route passed through to reach the destination network. Example FTOS>show ip bgp damp BGP table version is 210708, local router ID is 63.114.8.2 Status codes: s suppressed, d damped, h history, * valid, > best Path source: I - internal, a - aggregate, c - confed-external, r - redistributed, n - network Origin codes: i - IGP, e - EGP, ? - incomplete Network From Reuse Path FTOS> show ip bgp detail Display BGP internal information for the IPv4 Unicast address family. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Defaults show ip bgp [ipv4 unicast] detail none 394