Dell Inspiron 7000 Dell Inspiron 7000 Service Manual - Page 80
Remove the two 4-mm screws from the top inside of the combo bay.
View all Dell Inspiron 7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
This section provides the removal procedure for the palmrest assembly. 4-mm screw washer speaker wire harness and grounding strap palmrest assembly LED cable 6-mm screws (4) connector for speaker wire harness base assembly LED connector DC-DC board combo bay 4-mm screws (6) hard-disk drive bay battery bay This procedure assumes that you have removed the keyboard, thermal shield, and display assembly. To remove the palmrest assembly, follow these steps (see Figure 4-30): 1. Turn the unit over and place it face down. 2. Remove the two 4-mm screws from the top inside of the combo bay. 3. Remove the two 4-mm screws from the top inside of the battery bay. 4. Remove the two 4-mm screws from the top inside of the hard-disk drive bay. 4-46
4-46
’HOO±,QVSLURQ±²³³³±6HUYLFH±0DQXDO
3DOPUHVW±$VVHPEO\±
This section provides the removal procedure for the palmrest assembly.
)LJXUH±·´¶¿³±±3DOPUHVW±$VVHPEO\±5HPRYDO±
This procedure assumes that you have removed the keyboard, thermal shield,
and display assembly. To remove the palmrest assembly, follow these steps
(see Figure 4-30):
1.
Turn the unit over and place it face down.
2.
Remove the two 4-mm screws from the top inside of the combo bay.
3.
Remove the two 4-mm screws from the top inside of the battery bay.
4.
Remove the two 4-mm screws from the top inside of the hard-disk drive
bay.
palmrest
assembly
6-mm
screws (4)
base
assembly
4-mm
screws (6)
LED cable
speaker wire harness
and grounding strap
LED connector
connector
for speaker
wire
harness
DC-DC board
washer
4-mm screw
combo bay
hard-disk
drive bay
battery bay