Dell Inspiron 7000 Dell Inspiron 7000 Service Manual - Page 86
Shdnhuv
View all Dell Inspiron 7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
This section provides the removal procedure for the speakers. display latch speaker wire harness speakers (2) left speaker cover 4-mm screws (5) speaker cables (2) display latch spring right speaker cover This procedure assumes that you have removed the palmrest assembly from the base assembly and that you have removed the hard-disk drive heat shield and touch pad assembly. To remove the speakers, follow these steps (see Figure 4-34): 1. Remove any tape securing the speaker cables. 2. Remove the three 4-mm screws securing the left speaker cover. NOTE: Before removing the speaker cables and wire harness, be sure to note their routing through the slots and pins so you can correctly reinstall the components. 3. Remove the left speaker cover, speaker, and speaker cable. 4. Remove the speaker wire harness. 5. Remove the two 4-mm screws securing the right speaker cover. 6. Remove the right speaker cover, speaker, and speaker cable. The display latch is no longer secured by the speaker covers. Be careful not to lose the spring. 7. Remove the display latch and spring. To replace the speaker, resolder the speaker cable to the new speaker. When reinstalling the speakers, be especially careful to route the speaker cables and speaker wire harness through the appropriate slots and pins. 4-52