Denon AVR 4806 Owners Manual - Page 22

Easy Setup and Operation Extra Setup Preliminary measurements • The AVR-4806 has seven available amplifier channels, some of which can be assigned for powering speakers in ZONE2 and ZONE3, depending on the speaker system complement in the main room. If this functionality is not needed, skip this "Extra Setup" procedure and proceed to "Preliminary Measurements" ( page 22, 23). • This procedure is used to automatically determine the background noise, whether or not speakers are connected, and the polarities of the connected speakers. • To avoid affecting the measurements, turn off the airconditioner or any other device that makes noise and take the measurements with the room as quiet as possible. 1 Press the CURSOR D or H button to select the "Extra Setup", then press the CURSOR F button. • Switch to the "Extra Setup" screen. 1 Press the CURSOR D or H button to select the "Start", then press the CURSOR F button. • Start the preliminary measurements. 2 Press the CURSOR D or H button to choose the setting you want to change, then press the ENTER button. • Switch to the setting screen. For instructions on making the "Channel Setup" settings ( page 105). For instructions on making the "Power Amp Assign" settings ( page 106, 107). The speakers measured with this Auto Setup procedure are based on the setting of these "Channel Setup" and "Power Amp Assign" functions. 3 Once the settings are completed, press the ENTER button at the each setting screen. • The "Extra Setup" menu reappears. 4 Press the CURSOR D or H button to select the "Exit", then press the ENTER button. • Return to the "Auto Setup" screen. The screen shown at the below appears once the preliminary measurements are completed. 2 Press the ENTER button. • Switch to the "Speaker Detect Check" screen. [ First screen ] 3 Check the results of the speaker detection, then press the ENTER button. • Switch to the second screen. [ Second screen ] 4 If the check ends, press the ENTER button again. 22