HP 418800-B21 HP StorageWorks Replication Solutions Manager 4.0.1 user guide ( - Page 48

Job with host volume remount fails after an unclean unmount Problem A job with host volume remount fails and the replication manager logs the error message: The filename, directory name, or volume label syntax is incorrect for the operating system associated with this mount point. Explanation / resolution If a host volume is uncleanly unmounted, such as during an unplanned failover, the host OS or file system may retain information about the host volume. When the replication manager attempts to remount that same volume, the host treats the request as a duplication and the remount fails. To resolve this issue: 1. Ensure that the host volume is cleanly unmounted. 2. If necessary, clean up resources that were involved in the failed job. 3. After the host volume is cleanly unmounted, you can again use the replication manager to mount it. Logical volumes and volume groups in job commands Some command arguments require the selection or entry of a logical volume (a component of a volume group). Because the replication manager considers logical volumes and volume groups to be host volumes, you must select the resource from a host volumes list. There is not a separate list of logical volumes or volume groups. See also, host volumes and logical volumes and volume groups. Low-level refresh returns an error Problem When you perform a low-level refresh on a virtual disk or DR group, the replication manager may log the message: Unable to complete the requested action because of an unexpected error. Explanation / resolution This can occur when the replication manager is unable to discover a virtual disk or DR group. Use HP Command View EVA to verify that the virtual disk or DR group exists, and then retry the low-level refresh. The following table lists the CLUI commands and GUI actions that perform a low-level refresh. 48 Replication Solutions Manager