HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Services Comm - Page 142
ipv6 neighbor stale-aging
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
mac-address: Specifies the MAC address of the static neighbor entry (48 bits long, in the format of H-H-H). vlan-id: Specifies the VLAN ID of the static neighbor entry, in the range of 1 to 4094. port-type port-number: Specifies a Layer 2 port of the static neighbor entry by its type and number . interface interface-type interface-number: Specifies a Layer 3 interface of the static neighbor entry by its type and number. Description Use ipv6 neighbor to configure a static neighbor entry. Use undo ipv6 neighbor to remove a static neighbor entry. You can use a Layer 3 VLAN interface or a Layer 2 port in the VLAN to configure a static neighbor entry. • If the first method is used, the neighbor entry is in the INCMP state. After the device obtains the corresponding Layer 2 port information, the neighbor entry will go into the REACH state. • If the second method is used, the corresponding VLAN interface must exist and the port specified by port-type port-number must belong to the VLAN specified by vlan-id. After the static neighbor entry is configured, the device will relate the VLAN interface with the IPv6 address to identify the static neighbor entry uniquely and the entry will be in the REACH state. To remove a static neighbor entry, you only need to specify the corresponding VLAN interface and the neighbor address. Related commands: display ipv6 neighbors. Examples # Configure a static neighbor entry for Layer 2 port GigabitEthernet 1/0/1 of VLAN 100. system-view [Sysname] ipv6 neighbor 2000::1 fe-e0-89 100 GigabitEthernet 1/0/1 ipv6 neighbor stale-aging Syntax ipv6 neighbor stale-aging aging-time View undo ipv6 neighbor stale-aging System view Default level 2: System level Parameters aging-time: Age timer for ND entries in stale state, ranging from 1 to 24 hours. Description Use ipv6 neighbor stale-aging to set the age timer for ND entries in stale state. Use undo ipv6 neighbor stale-aging to restore the default. By default, the age timer for ND entries in stale state is four hours. 135