HP Color LaserJet CM4730 HP Color LaserJet CM4730 MFP - User Guide - Page 182
Con e-mail settings, Supported protocols - mfp service manual
View all HP Color LaserJet CM4730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
Configure e-mail settings Before you can send a document to e-mail, you must configure the device. NOTE The instructions that follow are for configuring the device at the control panel. You can also perform these procedures by using the embedded Web server. For more information, see Embedded Web server. Supported protocols The HP LaserJet CM4730 MFP models support Simple Mail Transfer Protocol (SMTP) and Lightweight Directory Access Protocol (LDAP). SMTP ● SMTP is a set of rules that define the interaction between programs that send and receive e-mail. In order for the device to send documents to e-mail, it must be connected to a LAN that has access to an e-mail server that supports SMTP. The SMTP server must also have Internet access. ● If you are using a LAN connection, contact your system administrator to obtain the IP address or host name for your SMTP server. If you are connecting through a DSL or cable connection, contact the internet service provider to obtain the SMTP server IP address. LDAP ● LDAP is used to gain access to a database of information. When the device uses LDAP, it searches a global list of e-mail addresses. As you begin to type the e-mail address, LDAP uses an autocomplete feature that supplies a list of e-mail addresses that match the characters you type. As you type additional characters, the list of matching e-mail addresses becomes smaller. ● The device supports LDAP, but a connection to an LDAP server is not required in order for the device to be able to send to e-mail. NOTE If you need to change the LDAP settings, you must change them by using the embedded Web server. For more information, see Embedded Web server, or see the Embedded Web Server User Guide on the device CD. Configure e-mail server settings Consult your system administrator or use the control panel to find the IP address for the SMTP server. Then use the following procedures to manually configure and test the IP address. Configure the SMTP gateway address 1. From the Home screen, touch Administration. 2. Touch Initial Setup. 3. Touch E-mail Setup, and then touch SMTP Gateway. 4. Type the SMTP gateway address, either as an IP address or as a fully qualified domain name. If you do not know the IP address or domain name, contact the network administrator. 5. Touch OK. 166 Chapter 12 Scan and send to e-mail ENWW