HP Color LaserJet CM4730 HP Color LaserJet CM4730 MFP - User Guide - Page 245
Load Tray Xx <type> <size>
View all HP Color LaserJet CM4730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
Table 16-1 Control-panel messages (continued) Control panel message Description Recommended action 22 EIO X BUFFER OVERFLOW To continue touch OK Too much data was sent to the EIO card in the specified slot (x). An incorrect communications protocol might be in use. Touch OK to print the transferred data. (Some data might be lost.) Check the host configuration. If this message persists, contact an HP-authorized service or support provider. (See the HP support flyer, or go to http://www.hp.com/support/ ljcm4730mfp.) 22 EMBEDDED I/O BUFFER OVERFLOW Too much data was sent to the embedded HP Touch OK to print the transferred data. To continue touch OK Jetdirect print server. (Some data might be lost.) 30.1.YY SCANNER FAILURE An error has occurred in the scanner. Check the scanner lock. Turn the MFP off and then on. If this message persists, contact an HPauthorized service or support provider. (See the HP support flyer, or go to http://www.hp.com/support/ljcm4730mfp.) 40 BAD EIO X TRANSMISSION To continue touch OK The connection between the MFP and the EIO card in the specified slot has been broken. Touch OK to clear the error message and continue printing. 40 BAD SERIAL TRANSMISSION To continue touch OK A serial data error (parity, framing, or line Touch OK to clear the error message. (Data overrun) occurred as data was being sent by will be lost.) the computer. 40 EMBEDDED I/O BAD TRANSMISSION A temporary printing error has occurred. To continue touch OK Turn the MFP off, and then turn the MFP on. If this message persists, contact an HPauthorized service or support provider. (See the HP support flyer, or go to http://www.hp.com/support/ljcm4730mfp.) 41.3 LOAD TRAY XX This is typically caused if two or more sheets of media stick together in the MFP or if the tray is not adjusted correctly. Reload the tray with the correct media size. Reconfigure the size in a tray so that the MFP will use a tray that contains the size required for the print job. Follow the instructions in the onscreen dialog box. 41.3 LOAD TRAY XX To use another tray touch OK The specified tray is loaded with media that is longer or shorter in the feed direction than the size adjusted for the tray. Touch OK to use another tray. Reconfigure the size in a tray so that the MFP will use a tray that is loaded with the size of media required for the print job. If the message does not clear automatically from the control-panel display, turn the MFP off, and then turn the MFP on. 41.X ERROR To continue touch OK A temporary printing error occurred. Touch OK to clear the error. If the error is not cleared, turn the MFP off, and then turn the MFP on. If this message persists, contact an HPauthorized service or support provider. (See the HP support flyer, or go to http://www.hp.com/support/ljcm4730mfp.) 49.XXXXX ERROR To continue turn off then on A critical firmware error has occurred. Remove third-party devices. Turn the MFP off, and then turn the MFP on. If this message persists, contact an HPauthorized service or support provider. (See ENWW Control-panel messages 229