HP Color LaserJet CM4730 HP Color LaserJet CM4730 MFP - User Guide - Page 52

Table 2-11 Jetdirect menus (continued) Menu item Sub-menu item Ping Test Sub-menu item Dest Type Dest IP4 Dest IP6 Packet Size Timeout Count Print Results Execute Values and Description This test is used to check network communications. This test sends link-level packets to a remote network host, then waits for an appropriate response. To run a ping test, set the following items: Specify whether the target device is an IPv4 or IPv6 node. IPV4: Type the IPv4 address. IPV6: Type the IPv6 address. Specify the size of each packet, in bytes, to be sent to the remote host. The minimum is 64 (default) and the maximum is 2048. Specify the length of time, in seconds, to wait for a response from the remote host. The default is 1 and the maximum is 100. Specify the number of ping test packets to send for this test. Select a value from 1 to 100. To configure the test to run continuously, select 0. If the ping test was not set for continuous operation, you can choose to print the test results. Select Yes to print results. If you select No (default), results are not printed. Specify whether to initiate the ping test. Select Yes to initiate the test, or No to not run the test. 36 Chapter 2 Control panel ENWW