HP Color LaserJet CM4730 HP Color LaserJet CM4730 MFP - User Guide - Page 247
Control panel message, Description, Recommended action, The MFP NVRAM is full. Some settings
View all HP Color LaserJet CM4730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 247 highlights
Table 16-1 Control-panel messages (continued) Control panel message Description Recommended action If this message persists, contact an HPauthorized service or support provider. (See the HP support flyer, or go to http://www.hp.com/support/ljcm4730mfp.) 60.X ERROR To continue turn off then on The tray specified by X is not lifting correctly. Follow the instructions in the onscreen dialog box. 62 NO SYSTEM To continue turn off then A problem exists with the MFP firmware. on Turn the MFP off, and then turn the MFP on. If this message persists, contact an HPauthorized service or support provider. (See the HP support flyer, or go to http://www.hp.com/support/ljcm4730mfp.) 64 ERROR To continue turn off then on A scan buffer error occurred. Turn the MFP off, and then turn the MFP on. If this message persists, contact an HPauthorized service or support provider. (See the HP support flyer, or go to http://www.hp.com/support/ljcm4730mfp.) 66.12.34 OUTPUT ACCESSORY FAILURE An output accessory is not functioning properly. 1. Turn off the MFP. 2. Verify that all external paper-handling devices are securely connected. 3. If the device uses cables, disconnect and reconnect them. 4. Turn on the MFP. If error reappears, write down the message and contact HP support. 66.XY.ZZ OUTPUT DEVICE FAILURE An error occurred in an external paperhandling accessory. 1. Turn the MFP power off. 2. Check that the accessory is properly seated on and connected to the MFP, without any gaps between the MFP and the accessory. If the accessory uses cables, disconnect and reconnect them. 3. Verify that there is no packaging material in or around the output device. 4. Turn the MFP power on. 5. If this message persists, contact an HPauthorized service or support provider. (See the HP support flyer, or go to http://www.hp.com/support/ ljcm4730mfp.) 68.X PERMANENT STORAGE FULL To continue touch OK The MFP NVRAM is full. Some settings saved in the NVRAM might have been reset to the factory defaults. Printing can continue, but some unexpected functions might occur if an error occurred in permanent storage. Touch OK to clear the message. If the message is not cleared, turn the MFP off, and then turn the MFP on. If this message persists, contact an HPauthorized service or support provider. (See the HP support flyer, or go to http://www.hp.com/support/ljcm4730mfp.) ENWW Control-panel messages 231