HP Dc7100 Troubleshooting Guide - Page 79

diskette. See the ROM Flash, Red Power LED

Get HP Dc7100 - Compaq Business Desktop PDF manuals and user guides
UPC - 829160356877
View all HP Dc7100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 79 highlights

POST Error Messages Diagnostic Front Panel LEDs and Audible Codes (Continued) Activity Beeps Possible Cause Recommended Action Red Power LED flashes seven times, once every second, followed by a two second pause. 7 System board failure (ROM detected failure prior to video). Replace the system board. Red Power LED flashes eight times, once every second, followed by a two second pause. 8 Invalid ROM based on bad checksum. 1. Reflash the ROM using a ROMPaq diskette. See the "ROM Flash" section of the Desktop Management Guide on the Documentation CD. 2. Replace the system board. Red Power LED flashes nine times, once every second, followed by a two second pause. 9 System powers on 1. Check that the voltage selector, but is unable to located on the rear of the power boot. supply (some models), is set to the appropriate voltage. Proper voltage setting depends on your region. 2. Replace the system board. 3. Replace the processor. Red Power LED flashes ten times, once every second, followed by a two second pause. 10 Bad option card. 1. Check each graphics card by removing the card (one at a time if multiple cards), then power on the system to see if fault goes away. 2. Once a bad card is identified, remove and replace the bad option card. 3. Replace the system board. Troubleshooting Guide www.hp.com A-17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
Troubleshooting Guide
www.hp.com
A–17
POST Error Messages
Red Power LED
flashes seven times,
once every second,
followed by a two
second pause.
7
System board
failure (ROM
detected failure
prior to video).
Replace the system board.
Red Power LED
flashes eight times,
once every second,
followed by a two
second pause.
8
Invalid ROM
based on bad
checksum.
1. Reflash the ROM using a ROMPaq
diskette. See the “ROM Flash”
section of the
Desktop
Management Guide
on the
Documentation
CD
.
2. Replace the system board.
Red Power LED
flashes nine times,
once every second,
followed by a two
second pause.
9
System powers on
but is unable to
boot.
1. Check that the voltage selector,
located on the rear of the power
supply (some models), is set to the
appropriate voltage. Proper voltage
setting depends on your region.
2. Replace the system board.
3. Replace the processor.
Red Power LED
flashes ten times,
once every second,
followed by a two
second pause.
10
Bad option card.
1. Check each graphics card by
removing the card (one at a time if
multiple cards), then power on the
system to see if fault goes away.
2. Once a bad card is identified,
remove and replace the bad option
card.
3. Replace the system board.
Diagnostic Front Panel LEDs and Audible Codes
(Continued)
Activity
Beeps
Possible Cause
Recommended Action