HP Designjet Z6200 HP Designjet Z6200 Photo Printer series - User's Guide: Eng - Page 171
The following graphic shows the take-up reel sensors and cable., Take-up reel sensor - foot brace
View all HP Designjet Z6200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
Take-up reel LED status Blinking quickly Blinking slowly Solid red Solid green Solid green Issue Take-up reel is not winding Take-up reel is not winding Take-up reel is not winding Take-up reel is not winding Take-up reel is winding in the wrong direction Print job interrupted? Yes No No No No Possible cause Possible solution The sensor beam was blocked for more than 3 seconds. Make sure that the take-up reel sensors are not blocked by a strip of paper, the collection bin if you are using the Z6200 1.1m printer, or any objects. See the following graphic. Make sure that the collection bin is placed behind the foot brace. Also ensure that the take-up reel power switch is in the On position. The sensor cables are loose or unplugged. Ensure that the sensor cables are correctly secured. There is too much resistance on the take-up reel motor. Ensure that the paper is not winding too tightly. A loopshaping core should be inserted and hanging as shown in step 10 of Use the take-up reel on page 37. The take-up reel power switch is in the Off position Ensure that the take-up reel power switch is in the On position. The take-up reel winddirection switch is in the wrong winding position. Flip the take-up reel winddirection switch to the correct position. After 3 seconds, the printer recognizes the problem and interrupts the print job. See the first error listed in this table. The following graphic shows the take-up reel sensors and cable. Troubleshoot paper 1. Take-up reel sensor 2. Take-up reel sensor and cable housing unit ENWW Take-up reel does not wind 163