HP LaserJet 4 Service Manual - Page 156
Required Tools, Hardware Review
View all HP LaserJet 4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
Required Tools Table 6-1 Required Tools QTY TOOL 1 #2 Magnetized Phillips Screwdriver (6-inch shaft) 1 Small Needle Nose Pliers 1 Small Flat-head Screwdriver (6-inch shaft) 1 5mm Nut driver Hardware Review All screws used in the printer are Phillips head, which require a Phillips screwdriver. Figure 6-1 shows the difference between a Phillips and a Pozidriv screwdriver. Note that the Phillips tip has more beveled surfaces. Caution Use of a Pozidriv screwdriver will damage the screw heads. Use Phillips only. Phillips Posidriv Figure 6-1 Comparing Phillips and Pozidrive Screws 6-2 Removal and Replacement
Required Tools
Hardware Review
All screws used in the printer are Phillips head, which require a
Phillips screwdriver.
Figure 6-1 shows the difference between a
Phillips and a Pozidriv screwdriver. Note that the Phillips tip has
more beveled surfaces.
Caution
Use of a Pozidriv screwdriver will damage the
screw heads. Use Phillips only.
QTY
TOOL
1
#2 Magnetized Phillips Screwdriver (6-inch shaft)
1
Small Needle Nose Pliers
1
Small Flat-head Screwdriver (6-inch shaft)
1
5mm Nut driver
Table 6-1
Required Tools
Posidriv
Phillips
Figure 6-1
Comparing Phillips and Pozidrive Screws
6-2 Removal and Replacement