HP LaserJet 4 Service Manual - Page 380
Removing the Holding Tray Belt
View all HP LaserJet 4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 380 highlights
Removing the Holding Tray Belt Figure A-20 Holding Tray Belt Cover Plate 1 Remove all the screws securing the plate (see Figure A-20, callout 1). 2 Remove (1) E-clip shown in Figure A-20, callout 2. 3 Remove the bushing underneath the E-clip. 4 Release (2) latch points shown in Figure A-20, callout 3. Note: The (2) washers on the gear beside the bushing are now loose. Remove and set aside. 5 Release the wires from the wire holder, allowing the cover to move aside to access the gears. (continued on next page) A -24 Duplexer
Removing the Holding Tray Belt
1
Remove all the screws securing the plate (see Figure A-20,
callout 1).
2
Remove (1) E-clip shown in Figure A-20, callout
2
.
3
Remove the bushing underneath the E-clip.
4
Release (2) latch points shown in Figure A-20, callout
3
.
Note:
The (2) washers on the gear beside the bushing
are now loose.
Remove and set aside.
5
Release the wires from the wire holder, allowing the cover to
move aside to access the gears.
(continued on next page)
Figure A-20
Holding Tray Belt Cover Plate
A -24 Duplexer