HP LaserJet 4 Service Manual - Page 241
Clearable Warning Messages
View all HP LaserJet 4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 241 highlights
Table 7-2 Clearable Warning Messages Message Displayed Meaning W1 IMAGE ADAPT MEMORY LOW, PAGE SIMPLIFIED The printer received a graphics print file that was too complex to print at the requested resolution. The printer automatically processed the file in the highest resolution possible with the memory installed. Add additional memory to print the file at full resolution. Check the printout for loss of data or print quality. W2 INVALID PERS REQUESTED LANGUAGE NOT AVAILABLE The job was not printed because the requested personality, such as PostScript, was not installed. Install the language in which the files are sent, together with enough memory to support that language. W3 JOB ABORTED The printer was forced to abort the print job because there INSUFFICIENT MEMORY was not enough installed memory to support the printer JOB CLEARED language used. W4 JOB 300/OFF W5 JOB 300/LTR W6 JOB 300/A4 W7 JOB 300/LGL The job was printed at 300 dpi with page protection set as specified in the message. To print the job as requested, install additional memory. W8 JOB 600/OFF W9 JOB 600/LTR W0 JOB 600/A4 The job was printed at 600 dpi with page protection set as specified in the message. To print the job as requested, install additional memory. WM MEM CNFIG N/A MEMORY SETTINGS CHANGED The printer did not have enough memory when switched on to support the previous settings for I/O buffering and /or Resource Saving, probably because you removed a memory SIMM, added a new personality SIMM, or added the optional duplex unit. WM CHK MEM CNFIG MEMORY SETTINGS CHANGED I/O Buffering and /or Resource Saving settings were altered when the printer was switched on because the printer did not have enough memory. This usually occurs after memory has been removed from the printer. (You can check settings by printing a self test.) WM [personality] MEM FULL [personality] MEMORY FULL The Resource Saving memory area for the specified personality is full. Press [CONTINUE]* to continue printing (some data will be lost). The current job will print, but some resources (downloaded fonts, etc.) may not be saved. If this error occurs frequently, you may need to adjust Resource Saving settings. *Press Go on the LJ5. Troubleshooting 7-11