HP Photosmart C5300 User Guide - Page 161

Chapter 14 If this did not solve the issue, try the next solution. Solution 4: Try printing with borders Solution: Try printing with borders by turning off the borderless option. For more information, see: "Print a borderless image" on page 58 Cause: Borderless printing was enabled. By selecting the Borderless option, your printed photo was enlarged and centered to fit the printable area of the page. Depending on the relative sizes of the digital photo and the paper on which you are printing, this could result in some parts of the image being cropped. A blank page came out while printing Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely solution first. If the first solution does not solve the problem, continue trying the remaining solutions until the issue is resolved. • Solution 1: Remove any extra pages or lines at the end of the document • Solution 2: Load paper in the input tray Solution 1: Remove any extra pages or lines at the end of the document Solution: Open the document file in your software application and remove any extra pages or lines at the end of the document. Cause: The document you were printing contained an additional blank page. If this did not solve the issue, try the next solution. Solution 2: Load paper in the input tray Solution: If the product has only a few sheets remaining, load more paper in the input tray. If there is plenty of paper in the input tray, remove the paper, tap the stack of paper against a flat surface, and reload the paper into the input tray. For more information, see: "Load paper" on page 37 Cause: The product picked up two sheets of paper. Ink is spraying the inside of the product when I print a photo Solution: Make sure you load photo paper in the input tray before you print a borderless print job. For more information, see: "Load full-size paper or small-size photo paper" on page 37 Troubleshooting 158 Troubleshooting