HP StorageWorks 2/32 HP StorageWorks SAN Switch 2/32 V4.2.X Installation Guide - Page 30
attached loosely as shown in, brackets using two 1/4-20 hex nuts with captive star lock washers
View all HP StorageWorks 2/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Installing the SAN Switch 2/32 Figure 5: Installing the rear mounting brackets (HP System/e rack-left rear upright) Note: This kit contains both left rails and right rails. The rails are marked Right and Left. 4. Assemble the outer rails by completing the following steps: a. Attach the left outer rail and the right outer rails to the rear mounting brackets using two 1/4-20 hex nuts with captive star lock washers attached loosely as shown in Figure 6. Do not tighten them; the nuts will be tightened later in step 7 on page 37. 30 SAN Switch 2/32 Version 4.2.x Installation Guide
Installing the SAN Switch 2/32
30
SAN Switch 2/32 Version 4.2.x Installation Guide
Figure 5:
Installing the rear mounting brackets (HP System/e rack-left rear upright)
Note:
This kit contains both left rails and right rails. The rails are marked
Right
and
Left
.
4.
Assemble the outer rails by completing the following steps:
a.
Attach the left outer rail and the right outer rails to the rear mounting
brackets using two 1/4-20 hex nuts with captive star lock washers
attached loosely as shown in
Figure 6
. Do not tighten them; the nuts will
be tightened later in
step 7
on page 37.