HP StorageWorks 2/32 HP StorageWorks SAN Switch 2/32 V4.2.X Installation Guide - Page 35
The components in, include, Insert the switch with the attached inner rails into the outer rails.
View all HP StorageWorks 2/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Installing the SAN Switch 2/32 Note: For factory integration only, tighten the #8-32 x 3/16-inch Phillips pan-head screw with thread lock and torque between 6 to 8 inch-pounds. Note: The plenum is a required part of this installation when the SAN switch 2/32 is installed in an HP 9000 or 10000 series, System/e or comparable EIA cabinet.The plenum allows air to dissipate at the rear of the rack, preventing overheating. 1 2 0013a Figure 10: Assembling the inner rails on a SAN Switch with plenum The components in Figure 10 include: 1 Plenum 2 Switch 6. Insert the switch with the attached inner rails into the outer rails. SAN Switch 2/32 Version 4.2.x Installation Guide 35
Installing the SAN Switch 2/32
35
SAN Switch 2/32 Version 4.2.x Installation Guide
Note:
For factory integration only, tighten the #8-32 x 3/16-inch Phillips pan-head
screw with thread lock and torque between 6 to 8 inch-pounds.
Note:
The plenum is a required part of this installation when the SAN switch 2/32 is
installed in an HP 9000 or 10000 series, System/e or comparable EIA cabinet.The
plenum allows air to dissipate at the rear of the rack, preventing overheating.
Figure 10:
Assembling the inner rails on a SAN Switch with plenum
The components in
Figure 10
include:
6.
Insert the switch with the attached inner rails into the outer rails.
1
Plenum
2
Switch
0013a
2
1