Lexmark E360d Service Manual - Page 43
-430, Transport motor service errors, Error, Description, Action, Printhead service
View all Lexmark E360d manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
4513-420, -430 Error Description Action 931.01 932.00 932.01 933.01 934.00 934.01 935.00 935.01 935.10 935.12 935.15 935.16 935.17 935.18 No first hsync Lost hsyncs Lost hsyncs Printhead boost signal failure Mirror motor lost lock. Mirror motor lost lock. No initial mirror motor lock Timed out waiting for mirror motor lock Printhead sweep error, swept through Hz range without finding the resonant frequency Printhead sweep error, coarse sweep state Printhead open-loop error, check prelim amp state Printhead open-loop error, enable amp Kp state Printhead closed-loop error, amp Kp failed to converge Printhead closed-loop error, enable amp Ki state Replace the printhead. See "Printhead service check" on page 2-37. 935.19 935.20 Printhead closed-loop error, amp Ki failed to converge Printhead closed-loop error, enable offset controller state 935.21 Printhead closed-loop error, load scan regs state 935.22 Printhead closed-loop error, fwd and rev capture times differ by too much 935.23 Printhead closed-loop error, check sweep accuracy state 935.25 Printhead closed-loop error, off-resonant PI effort state 935.26 Timed out on POR sweep 935.27 Exceeded maximum open loop drive level when configuring for sweep re-try. 935.28 Exceeded maximum open loop drive level when setting operating Hz. Transport motor service errors 936.01 936.02 No lock detected at normal motor start No lock detected at motor start for motor ID Replace the main motor gear drive. See "Main motor service check" on page 2-26 936.03 No halls detected at motor start 936.04 Failed to stop within timeout 936.05 Stall detected during speed control Diagnostics information 2-17